3325_0 42STH38 NEMA-17 Bipolar Stepper with 5.18:1, 3325
This NEMA-17 motor has an integrated Planetary gearbox with a 52/11 :1 ratio. It comes with the rear shaft exposed, so you can mount an encoder or shaft coupler.
At the output of the gearbox, the step angle is a little under 0.35°. When using the step angle in calculations, you should derive the exact step angle by dividing 1.8° by the gearbox reduction ratio.
At 1.7 Amps, this stepper motor can produce a maximum torque of 18.6 kg-cm. However, the gearbox is only rated for 18 kg-cm of continuous torque. Loading this gearbox stepper beyond the torque rating of the gearbox will shorten its useful life.
The following diagram shows how to connect the motor wires to the board connectors to produce a clockwise rotation in the stepper motor when increasing position. To wire for counter-clockwise rotation when increasing position, reverse the red and blue wires.
Note: Make sure to unplug the power cord from the motor controller before switching wires around.
The rear shaft of this motor can be equipped with the HKT22 Optical Encoder for applications where you need to keep track of the exact position, velocity, or acceleration of the motor.
The mounting holes on this motor are compatible with the 3338 - Mounting Bracket (NEMA17).
 |
Connecting the motor directly to a power supply will destroy the motor and void the warranty. If you want to check your motor make sure it is connected to a constant current / chopper drive controller. |
.jpg)
| Motor Type | Bipolar Stepper |
| Manufacturer Part Number | 42STH38-1684B / 36JXS60K5.18 |
| Step Angle | 0.35° |
| Step Accuracy | ± 5 % |
| Holding Torque | 18 kg·cm |
| Rated Torque | 18 kg·cm |
| Maximum Motor Speed | 200 RPM |
Electrical Properties
| Recommended Voltage | 24 V DC |
| Rated Current | 1.7 A |
| Coil Resistance | 1.7 Ω |
Physical Properties
| Shaft Diameter | 8 mm |
| Rear Shaft Diameter | 3.9 mm |
| Mounting Plate Size | NEMA - 17 |
| Weight | 457 g |
| Number of Leads | 4 |
| Wire Length | 300 mm |
Gearbox Properties
| Gearbox Type | Planetary |
| Gear Ratio | 5 2⁄11 : 1 |
| Backlash Error | 1 1⁄2° |
| Maximum Strength of Gears | 18 kg·cm |
| Shaft Maximum Axial Load | 49.1 N |
| Shaft Maximum Radial Load | 98.1 N |
