XBee Adapter Board, 32403


This low cost adapter board is sold as a raw PCB and is perfect for interfacing any XBee or XBee Pro with the Propeller or any other 3.3 V microcontroller.


Two 10-pin sockets with 2mm spacing are included and can be soldered to the PCB for easy mounting of the XBee RF Module.

One 40-pin header with 2.54mm spacing is also included and can be soldered to the PCB for easy accommodation to breadboard applications. Board dimensions: 2.95 x 2.56cm

Kit Contents:

  • (1) XBee Adapter Board PCB 
  • (2) 1x10 2mm socket 
  • (1) 40-pin single row header 


Tools Required:

  • Soldering Iron
  • Solder 
  • Flux 
  • Diagonal cutters 


Associated Modules:

  • XBee 2mW Chip Antenna (XB24-ACI-001) 
  • XBee 2mW Wire Antenna (XB24-AWI-001) 
  • XBee Pro 60mW Chip Antenna (XBP24-ACI-001)
  •  XBee Pro 60mW Wire Antenna (XBP24-AWI-001) 


Note: The XBee Adapter Board includes two additional Vdd and Vss pins that are not needed for operation of the XBee RF Module. When cutting the 40-pin header, be sure to only solder the first 10 pins on each side, leaving the bottom two pins labeled Vdd and Vss not connected.