3333_0 57STH56 NEMA-23 Bipolar Stepper with 15:1 Gearbox
This NEMA-23 motor has an integrated Planetary gearbox with a 15 3/10 :1 ratio. It comes with the rear shaft exposed, so you can mount an encoder or shaft coupler.
This NEMA-23 motor has an integrated Planetary gearbox with a 15 3/10 :1 ratio. It comes with the rear shaft exposed, so you can mount an encoder or shaft coupler.When connected to a 1067 phidgetstepper bipolar HC the 3333 has a maximum speed of 116 RPM. At the output of the gearbox, the step angle is approximately 0.12°. When using the step angle in calculations, you should derive the exact step angle by dividing 1.8° by the gearbox reduction ratio.
At 2.8 Amps, this stepper motor can produce a maximum torque of 192 kg-cm. However, the gearbox is only rated for 150 kg-cm of continuous torque. Loading this gearbox stepper beyond the torque rating of the gearbox will shorten its useful life.
The 3333 stepper motor connects to a bipolar motor controller such as the 1067 - PhidgetStepper Bipolar HC.
The following diagram shows how to connect the motor wires to the board connectors to produce a clockwise rotation in the stepper motor when increasing position. To wire for counter-clockwise rotation when increasing position, reverse the red and blue wires.
Note: Make sure to unplug the power cord from the motor controller before switching wires around.
The rear shaft of this motor can be equipped with the HKT22 Optical Encoder for applications where you need to keep track of the exact position, velocity, or acceleration of the motor.
Resources:
Motor Properties
| Motor Type | Bipolar Stepper |
| Manufacturer Part Number | 57STH56-2804B / 56JXS300K15 |
| Step Angle | 0.12° |
| Step Accuracy | ± 5 % |
| Holding Torque | 150 kg·cm |
| Rated Torque | 150 kg·cm |
| Maximum Speed (w/1067 Motor Controller) | 116 RPM |
| Acceleration at Max Speed (w/1067 Motor Controller) |
1.2E+06 1/16 steps/sec² |
Electrical Properties
| Recommended Voltage | 12 V DC |
| Rated Current | 2.8 A |
| Coil Resistance | 900 mΩ |
| Phase Inductance | 2.5 mH |
Physical Properties
| Shaft Diameter | 12 mm |
| Rear Shaft Diameter | 3.9 mm |
| Mounting Plate Size | NEMA - 23 |
| Weight | 1.3 kg |
| Number of Leads | 4 |
| Wire Length | 300 mm |
Gearbox Properties
| Gearbox Type | Planetary |
| Gear Ratio | 15 3⁄10 : 1 |
| Backlash Error | 1 1⁄2° |
| Maximum Strength of Gears | 150 kg·cm |
| Shaft Maximum Axial Load | 100 N |
| Shaft Maximum Radial Load | 250 N |
Warning
 |
Connecting the motor directly to a power supply will destroy the motor and void the warranty. If you want to check your motor make sure it is connected to a constant current / chopper drive controller. |
