1014_3 Phidget Interface Kit 0/0/4, 1014_3

Due to parts and components going obsolete and becoming unavailable, the 1014_3 has moved to a new processor that is not supported under Phidget21. If you're using our old libraries you must upgrade to Phidget22 before you can make use of this Phidget

The Phidget Interface Kit 0/0/4 allows you to control high power devices such as incandescent light bulbs, fans, and pumps by electronically switching power on and off.

The 1014 has 4 Relay Outputs for switching AC or DC power; the relays are Single Pole Double Throw (SPDT).

Note: This board is not suitable for switching signals. It takes at least 100mA of current to bridge the oxide layer that forms on the relay contacts, and most signals will not meet this requirement. If you need to switch signals, check out the 1017 - PhidgetInterfaceKit 0/0/8.

Comes Packaged with

Hardware mounting kit:

• 4x M3 Bolts (2cm Length)
• 4x Plastic spacers (5mm Length)
• 4x M3 Nuts