Cytron Maker pHAT - GPIO extension for Raspberry Pi

£10.74 £8.95

Cytrons PHAT shield for Raspberry Pi has signed GPIO pins to facilitate the recognition of individual pins, three programmable buttons, status LEDs for GPIO ports and an active buzzer.


Maker pHAT is designed to be the same size as Raspberry Pi Zero board, it stacks perfectly on top of Rpi Zero with the four mounting holes aligned.  We do advise getting Raspberry Pi Zero WH (pre-soldered header pins) for beginners.

It is also compatible with Raspberry Pi 3B, 3B+, 3A+,  and of course the latest 4B too. You just need to insert the 2x20 stacking header(included), as photo shows:

  • Raspberry Pi Zero size, stack perfectly on to Pi Zero Series of SBC (Single Board Computer).
  • Compatible with standard size Raspberry Pi 3B/3B+/4B1GB/4B2GB/4B4GB, medium size Raspberry Pi 3A+ and smaller size Raspberry Pi Zero/W/WH.
  • Standard Raspberry Pi GPIO footprint.
  • LED array for selected GPIO pins (GPIO 17, 18, 27, 22, 25, 12, 13, 19).
  • 3x onboard programmable push buttons (GPIO 21, 19 and 20, need to configure as input pull up).
  • Onboard active buzzer (GPIO 26).
  • Proper label for all GPIOs, including SPI, UART, I2C, 5V, 3.3V, and GND.
  • Utilize USB Micro-B socket for 5V input and USB to UART communication.
  • USB serial facilitated by the CH340, Rev1.10 uses FT231X as the USB to UART
  • Input voltage: USB 5V, from the computer, power bank or standard USB adapter.
  • Purple PCB!