3532_1 Hollow Shaft Optical Encoder IHC3808
Ideal for use with motors, this hollow-shaft encoder fits easily onto an 8mm shaft.
Note: The 3532_1 is the same as the 3532_0, except this revision has a 5-pin connector soldered to the end of the cable so it can be plugged directly into a Phidgets encoder interface.
This sturdy optical quadrature encoder can be attached to the 8mm rear shaft of a motor without need for a shaft coupler. It has 500 counts (full quadrature cycles) per rotation and can be installed easily by fitting it over the shaft and tightening the set-screw. This encoder makes use of the index channel, sending one pulse for every full rotation.
- Includes mounting screws and washers
Quadrature Encoder
- 360 counts per revolution
- Index Channel
- Push-pull Output
- Hollow shaft installation
| Function | 3532 - Encoder | 3019 - Phidget cable |
|---|---|---|
| +5V | Red | Red |
| Ground | Black | Black |
| Data (A) | Green | White |
| Data (B) | White | Brown |
| Index (Z) | Yellow | Green |
|
Encoder Properties |
|
|
Output Circuit Type |
Push-Pull (Single-Ended) |
|
Controlled By |
Encoder Interface |
|
Encoder Resolution |
500 CPR |
|
Encoder Speed Max |
4500 RPM |
|
Electrical Properties |
|
|
Supply Voltage Min |
5 V DC |
|
Supply Voltage Max |
5 V DC |
|
Output Frequency Max |
100 kHz |
|
Physical Properties |
|
|
Shaft Diameter |
(Inner) 8 mm |
|
Cable Length |
1 m |
|
Shaft Maximum Axial Load |
10 N |
|
Shaft Maximum Radial Load |
20 N |
|
Operating Humidity Min |
30 %RH |
|
Operating Humidity Max |
(Non-condensing) 85 %RH |
|
Operating Temperature Min |
-10 °C |
|
Operating Temperature Max |
70 °C |
|
IP Rating |
IP54 |
|
Weight |
121 g |
| Image | Product Name | Description | Price | Action | |
|---|---|---|---|---|---|
 |
3530_1 Phidget Optical Rotary Encoder | This encoder can measure rotation at speeds of up to 3000 RPM and plugs into a Phidgets Encoder Interface.View Detail... |
£69.36
£57.80
|
||
 |
3531_0 Optical Rotary Encoder HKT22 | This low-cost encoder is designed to fit on the rear shaft of our stepper motors. Measure the rotation of your motor even when it stalls or missteps. Includes:
£34.68
£28.90
|
