Use this kit to turn your Linear actuator control Board into a self contained demonstration unit for any 6 volt Actuonix Motion Devices actuator with position feedback.
This linear potentiometer is used to create a variable voltage to input to the LAC board in order to command the actuators position.
It has 3 solder terminals. Two terminals are the reference voltage which you must apply a fixed ground and 3 volt source. The third terminal is the output voltage which will vary between 0 and 3.3 volts, depending on the positionof the slide.
This website uses cookies to improve your experience. By clicking “Accept”, you consent to the use of ALL the cookies. However you may visit Cookie Settings to provide a controlled consent.
