1062_1B Phidget Stepper Unipolar 4 Motor
£61.20
Accurately control up to 4 unipolar stepper motors with this controller.
Connects to a USB port.
Details
The PhidgetStepper Unipolar allows you to control the position, velocity, and acceleration of up to 4 unipolar stepper motors. The 1062 can be used in applications that require precise positioning and continuous rotation, at low cost.
Note: Because most unipolar motors are resistive limitied, the 1062 does not support current control. If your motor requires current control, have a look at the 1067 - PhidgetStepper Bipolar HC.
Comes Packaged with
- Hardware mounting kit:
- 4x M3 Bolts (2cm Length)
- 4x Plastic spacers (5mm Length)
- 4x M3 Nuts
Warning
Make sure the power supply is unplugged before attaching or removing wires from the terminal blocks. Failure to do so could cause permanent damage to the PhidgetStepper board. |