Servo Extension via CAT6 (Receiving Board)

Product Code:
3116-4527-0001
£13.78 £11.48

This board takes a servo signal sent over a CAT6 cable and breaks it out to servo compatible TJC8 pins.

Servo Extension via CAT6 (Receiving Board) Servo Extension via CAT6 (Receiving Board) Servo Extension via CAT6 (Receiving Board) Servo Extension via CAT6 (Receiving Board)
Servo Extension via CAT6 (Receiving Board)

This Receiving Board is the counterpart to the Sending Board (3116-2745-0001)

COMPATIBILITY

Ethernet Cables: While CAT6 is the recommeded cable, the RJ45 connector this Boosted Servo Extension uses is also compatible with CAT5, CAT5e, CAT6a, and CAT8 cables.

Servos: This Boosted Servo Extension is compatible with any servo which uses a PWM signal. This is just about any servo in the hobby or small-medium robotics industries.

Actobotics Electronics: While this Boosted Servo Extension uses CAT6, it utilizes a newer protocol than the Actobotics CAT6 boards (605102, 605103, 902MSD) making them incompatible with each other.

Weight Board = 11.3g Board with case and hardware - 20.4g
Recommended Voltage Range 6V -15V
Max Voltage Range 3.3v - 18V
Signal Channels 4
Max Current (When powered at Receiving Board) 16A Total (4A per Channel)
Max current over CAT6 (When powered at Sending Board) 4A Total
Servo compatibility Analog & Digital
Maximum Recommended Ethernet Cable Length 100ft (30M)
Power Compatibility TJC8, XT30, 3mm Solder Holes
Product Enquiry