3579_0 Linear Potentiometer - KTC-75mm

Product Code:
3579
£90.98 £75.82
  • Buy 5 for £83.40 £69.50 each and save 8%
  • Buy 10 for £80.56 £67.13 each and save 11%
  • Buy 50 for £75.12 £62.60 each and save 17%
  • Buy 100 for £70.76 £58.97 each and save 22%

The KTC series linear potentiometer is designed to provide position feedback for systems with moving parts.

This potentiometer can extend to a length of 75mm and is protected by an anodized aluminium outer casing.

3579_0 Linear Potentiometer - KTC-75mm
3579_0 Linear Potentiometer - KTC-75mm

The KTC series linear potentiometer is designed to provide position feedback for systems with moving parts. This potentiometer can extend to a length of 75mm and is protected by an anodized aluminium outer casing.

This sensor can be used with any device with an analog input. Simply cut and connect a 3-wire sensor cable as described in the connection section below. 

This sensor connects to any device with an Analog Input

You can use an analog sensor cable to connect the potentiometer to your Phidget. Just snip off the connector from one end of the sensor cable, strip the ends of the wires and connect them using the screw terminals as shown in the diagram below.

Comes packaged with:

  • 2 Mounting Brackets
  • A Wiring Harness with Cap
  • A Rubber Seal
  • A Ball Joint Attachment
  • 4 Mounting Screws

Sensor Properties

Sensor Type Input (Linear)
Linear Travel 75 mm
Potentiometer Impedance 5 kΩ
Repeatability Error Max 0.02 %

 

Physical Properties

Material Anodized Aluminium
IP Rating IP65
Lifespan 100 million actuations
Weight 180 g
Product Enquiry