Optical Encoder Pair Kit for Micro Metal Gearmotors, 5V
Add quadrature encoders to your LP, MP, or HP micro metal gearmotors (extended back shaft version required) with this kit consisting of two sensor boards, and two 5-tooth encoder wheels.
Add quadrature encoders to your LP, MP, or HP micro metal gearmotors (extended back shaft version required) with this kit consisting of two sensor boards, two 3-tooth encoder wheels, and two 5-tooth encoder wheels.
The installed system does not exceed the 12 mm × 10 mm cross section of the motors and extends only 5 mm beyond the plastic motor end cap. Using the 5-tooth wheel yields 20 counts per revolution. This version is intended for use at 5 V.
Note: This board is not compatible with the HPCB micro metal gearmotors; it is only compatible with LP, MP, and HP dual-shaft micro metal gearmotors.
- Size: 9.6mm x 11.6mm
- Weight: 0.7g (weight of the pair)
- Voltage: 5V
- Average input current: 12mA
File downloads
-
Datasheet for the Sharp GP2S60 compact reflective photointerrupter (164k pdf)
-
Optical Encoder for Micro Metal Gearmotors drill guide (30k dxf)
This DXF drawing shows the locations of all of the board’s holes.
