RMCS-2204

NEMA23 High Torque DC Servo Motor 200RPM With UART/12C/PPM Drive

£74.58 £62.15

This Encoder DC Servo motor solution integrates an 0.2deg resolution optical encoder and a high power electronic servo drive on an Industrial grade high torque DC motor.

Or

It supports UART/I2C/PPM/Analog signals directly for absolute speed and absolute position control. This solution works extremely well for slow speeds by providing high correction torque through a closed PI control loop.

The Motor is a Industrial grade 200RPM high torque motor with a massive torque of 32kgcm in small size. The motor has a metal gearbox with all high quality metal gears and has a off-centered shaft.

Power and Input Terminal Assignments

Terminal No.

Terminal Name

Wire Color

 

Description

Terminal 1

GND

BLACK

 

Ground should be connected to negative of supply of battery

Terminal 2

SCL/PPM/Analog

BROWN

 

I2C clock / PPM input signal / Analog Voltage Input

Terminal 3

SDA/Analog Sense

RED

 

I2C Data / Analog Input Sense

Terminal 4

UART TXD

ORANGE

 

UART Data Transmit of speed controller, connect to RXD of host

Terminal 5

UART RXD

YELLOW

 

UART Data Receive of speed controller, connect to TXD of host

Terminal 6

V+ (12V)

GREEN

 

V+ should be connected to positive of supply or battery

High Torque DC Geared Motor Features

  • 200RPM 12V DC motors with Metal Gearbox and Metal Gears

  • 18000 RPM base motor

  • 6mm Dia shaft with M3 thread hole 

  • Gearbox diameter 37 mm.

  • Motor Diameter 28.5 mm

  • Length 63 mm without shaft

  • Shaft length 15mm

  • 180gm weight

  • 32kgcm torque

  • No-load current = 800 mA

  • Load current = upto 7.5 A(Max)

Encoder and Drive Specifications

  • Zero-backlash DC servo performance

  • 0.2deg resolution optical encoder integrated on motor output shaft

  • High-Current DC Servo motor driver integrated with the motor

  • Absolute (32bit) Motor position control interface via UART, I2C, PPM signal and analog input

  • Accurate Motor speed control interface via UART, I2C, PPM signal and analog input

  • Industrial Grade Aluminum housing for motor and drive

  • Compatible with NEMA 23 mounting setup

  • Speed and position can be controlled using a terminal or MCU via simple UART commands

  • I2C master device can control multiple RMCS-220x via simple I2C command structures

  • An RC receiver or any PPM source can directly control the speed of the motor

  • An analog signal or fixed analog voltage from a potentiometer can directly control the speed of the motor