3F/H25T Spline Servo to 1/4" Shaft Coupler (Set Screw) (525136)
This servo to shaft coupler is intended to fasten a 1/4" shaft to the output spline of a servo that has a 25 Tooth (H25T) Spline.
- Just one left in stock - the replacement product is 4010-0025-0250
This 25T shaft coupler is intended to mate a servo spline to a ¼” diameter shaft. While it will accept a round shaft, the most common setup is to install a d-shaft so that the set-screw can apply pressure to the flat section.
The cupped point of the set-screw will actually start to burrow into the flat, creating excellent resistance to the shaft moving or the set-screw backing out
- Requires a 3/32" Hex Key (sold separately)
|Servo Spline Compatibility||25 Tooth (H25T Spline)|