GoPiGo2 Robot Base Kit

Only 1 left
Product Code:
GOPIGO_BASE
£126.72 £105.60

The GoPiGo2 Base Kit is perfect if you already have a Raspberry Pi and want to get it moving. It includes the GoPiGo2 board, chassis, wheels, motors, encoders, and power battery pack

Also need a Raspberry Pi? The best value is the Starter Kit, which includes all you need to get started from scratch! .

GoPiGo Robot Base Kit GoPiGo board front view GoPiGo Robot Base Kit GoPiGo board underside GoPiGo Robot Base Kit GoPiGo Robot Base Kit parts GoPiGo Robot Base Kit with RaspberryPi fitted GoPiGo Robot Base Kit with ultrasonic sensor fitted GoPiGo Robot Base Kit side view GoPiGo base kit + RaspberryPi GoPiGo fitted with ultrasonic sensor
GoPiGo Robot Base Kit

What’s included?

  • GoPiGo2 board (red board)
  • chassis (frame, wheels, hardware)
  • motors
  • encoders
  • power battery pack & cable (batteries not included)

The GoPiGo is stacked on top of the Raspberry Pi without the need for any other connections. Communication between the two occurs over the I2C interface. You can connect motors and sensors to the GoPiGo.

The GoPiGo has 4 ports on it on which various Grove Sensors can be connected. There is an Analog, Digital, Serial and I2C port on the GoPiGo. There is also a connector to connect the Servo motors and another connector to connect upto 3 line sensors on the GoPiGo.

All the motor control and sensor I/O on the GoPiGo is done by an ATMEGA328 microcontroller on the GoPiGo. The microcontroller acts as an interpreter between the Raspberry Pi and the GoPiGo. It sends, receives, and executes commands sent by the RaspberryPi.

In addition, the GoPiGo allows you the Raspberry Pi to access some Grove sensors directly. The Raspberry Pi has an I2C Bus by which sensors connected to the I2C Ports can be directly accessed.

Technical Specifications:

  • Operating Voltage: 7-12V
  • Current usage:
    • 300-500 mA (Idle with the Raspberry Pi Model B+)
    • 800 mA-2A (Motors, camera and servo running with the Raspberry Pi Model B+)
  • External Interfaces:
    • I2C– 1Port
    • Serial– 1 Port
    • Analog– 1 Port
    • Digital/PWM- 1Port
  • Motor controller: SN7544
  • Encoders
    • 2 Optical encoders with 18 pulse counts per rotation
  • Wheel Diameter: 65mm
  • MCU: Atmega 328
We found other products you might like...

What’s not included?

Suggested components required to make it a mobile robot (NOT INCLUDED):

  • Raspberry Pi (GoPiGo is compatible with all version of the Raspberry Pi): This board is the main brains of the robot that will connect to the GoPiGo board.
  • Mini Wi-Fi Dongle: Can be plugged in to the Raspberry Pi so you can unplug the ethernet cord and make it function as a remote control, mobile car.
  • MicroSD Card: Required “hard drive” for the Raspberry Pi (comes with Dexter Industry’s custom software “Raspbian for Robots”).
  • Ethernet Cable: Required for plugging in to your computer to program the GoPiGo.
  • Power Supply: Wall plug to power your Raspberry Pi while you are programming it, rather than using the batteries.
  • Batteries: GoPiGo requires 8 AA batteries, which are not included.
Product Enquiry