Face Visor Production Kit

Product Code:
Visor_Kit
As low as £67.39 £56.16

Face Visor Production Kit

All you need to produce your own face visors.

A low cost way to produce high quality reusable face visors in minutes for your team, family or if you'd like to make donations, for your local hospices, homes and healthcare providers.

The masks are reusable, strong, cleanable and comfortable to wear. 

Face Visor Production Kit Face Visor Production Kit
Face Visor Production Kit

These kits are easy to use and will allow you to produce as many face visors as you need.

Each mould is expected to last at least 50 masks depending on the care with which it is treated. The moulds and all other supplies can be replaced to allow you to continue to produce visors for as long as it is necessary.

This means that you will have what you need for your team no matter what the supply chain is like during the crisis as the virus waves around the world.  

The more masks you produce the cheaper they are each.

Every kit purchased contributes to our own efforts, producing PPE for our local hospices, homes and healthcare providers.

Kit Cost Cost Each Mask
10 £56.16 £5.16
30 £135.02 £4.50
100 £320.00 £3.20

 

An easy to use kit that allows you to produce facemasks when you need them for your team. Have a new starter? just produce them a couple of visors.

Each Kits Includes

  • Mould
  • Casting resin
  • screens
  • making equipment
  • elastic
  • Headband adjusters
  • Optional sticky back headband foam

The kit comes with everything you need to produce either 10, 30 or 100 masks and you can order more supplies to produce even more.

 

Moulds

Easy to use, high quality silicone


Casting Resin

Two part Polyurathane casting resin

Mixing/pouring time 2 minutes

Setting time 20-40 minutes

 

Screens

High quality 0.5mm PETG clear visors protected both sides with removable cover for crystal clear robust protection

 

Self assembly required.

 

 

The easy to make process is three steps and takes just a few minutes

Step - Resin

  • Draw part A & B resins into the separate needle free syringes 
  • Add these and the colour to a disposable cup/bowl
  • Mix well and pour into the mould
  • Leave to set for around 30 minutes

 

Step 2 - Prepare components

  • Cut the elastic and the foam to length
  • Remove your casting
  • Drill two small holes in the casting for the elastic

 

Step Three - Assemble

  • Stick the foam to the inside face of the casting
  • Tie the ends of the elastic each side of the headband and slip on the adjusting toggle
  • Partially remove the protective film from the visor, then clip onto the casting

 

Remove the film when ready to use!

Product Enquiry