ENC1001
ENC1001 Quadrature Encoder Phidget, ENC1001
£18.60 £15.50
This encoder interface can measure 250,000 quadrature cycles per second at 1000 Hz.
The ENC1001 interfaces with any 5V quadrature encoder. A quadrature encoder is the most commonly used feedback device for a DC or stepper motor. With an encoder, you can keep track of the rotation angle of your motor, which then allows you to control the position and velocity in your code. This Phidget connects to your computer through a VINT Hub.
Features
- Works with all 0-5V push-pull quadrature encoders
- Read at speeds of up to 250,000 quadrature cycles per second
- Supports data rates of up to 1000 Hz
- Save power by disabling the encoder output when not in use
| Board Properties | |
|---|---|
| Controlled By | VINT |
| VINT Communication Speed Max | 1 Mbit/s |
| Encoder Interface | |
| Number of Encoder Inputs | 1 |
| Count Rate Max | 1E+06 pulses/s |
| Encoder Interface Resolution | x4 |
| Time Resolution | 15 ns |
| Encoder Input Low Voltage Max | 1 V DC |
| Encoder Input High Voltage Min | 3 V DC |
| Sampling Interval Min | * 1 ms/sample |
| Sampling Interval Max | 1 s/sample |
| Pull-up Resistance (Open Collector) | N/A |
| Pull-down Resistance (Line Driver) | N/A |
| Electrical Properties | |
| Current Consumption Min | (unconfigured) 30 μA |
| Current Consumption Max | encoder current + 6.5 mA |
| Physical Properties | |
| Operating Temperature Min | -40 °C |
| Operating Temperature Max | 85 °C |
