TB67H420FTG Dual/Single Motor Driver Carrier

Product Code:
2999
£7.98 £6.65

This breakout board makes it easy to use Toshiba’s TB67H420FTG brushed DC motor driver, which can operate in either dual-channel mode for independent bidirectional control of two motors or single-channel mode for driving one motor with increased current.

It has a wide operating voltage range of 10 V to 47 V and can deliver a continuous 1.7 A to each motor channel, or 3.4 A in single-channel mode. 

Dimensions*

  • Size- 1.2" x 1.0"
  • Weight: 3.5g
*Without included hardware
TB67H420FTG Dual/Single Motor Driver Carrier TB67H420FTG Dual/Single Motor Driver Carrier. TB67H420FTG Dual/Single Motor Driver Carrier,bottom view with dimensions Pinout diagram of the TB67H420FTG Dual/Single Motor Driver Carrier TB67H420FTG Dual/Single Motor Driver Carrier with included headers and terminal blocks TB67H420FTG Dual/Single Motor Driver Carrier with included headers and terminal blocks soldered TB67H420FTG Dual/Single Motor Driver Carrier with included headers and terminal blocks soldered. TB67H420FTG Dual/Single Motor Driver Carrier driving two motors in dual-channel mode TB67H420FTG Dual/Single Motor Driver Carrier driving a motor in single-channel mode Schematic diagram of the TB67H420FTG Dual/Single Motor Driver Carrier
TB67H420FTG Dual/Single Motor Driver Carrier

The TB67H420FTG from Toshiba is an H-bridge motor driver IC that can be used for bidirectional control of one or two brushed DC motors at 10 V to 47 V. It can supply up to about 1.7 A continuously to each of two separate motors or about 3.4 A to a single motor, and it can tolerate peak currents up to 4.5 A per channel (dual) or 9 A (single) for a few seconds, making it a good choice for small- to medium-sized motors that run at higher voltages. 

Included hardware

This product ships with all surface-mount components—including the TB67H420FTG driver IC—installed as shown in the product picture. However, soldering is required for assembly of the included through-hole parts: one 1×20-pin breakaway 0.1″ male header and three 2-pin, 3.5 mm terminal blocks (for board power and motor outputs).

Features

  • Single- or dual-channel H-bridge motor driver (can drive one or two DC motors)
  • Motor supply voltage: 10 V to 47 V
  • Output current:
    • up to 1.7 A continuous (4.5 A peak) per motor in dual-channel mode
    • up to 3.4 A continuous (9 A peak) in single-channel mode
  • Configurable current chopping actively limits motor current to 4.5 A per channel (dual) or 9 A (single) by default; can be lowered with external resistors or voltage sources
  • No separate logic supply needed; inputs are 3V- and 5V-compatible
  • Flexible input interface provides several options for control
  • Under-voltage lockout and protection against over-current/short-circuit and over-temperature
  • Open-load detection
  • Carrier board adds reverse-voltage protection up to 40 V
  • Active-low error outputs indicate over-current, over-temperature, or open-load condition
  • Compact size (1.0″ × 1.2″)
  • Exposed solderable ground pad below the driver IC on the bottom of the PCB
Motor Driver TB67H420FTG
Motor Channels 2
Minimum operating voltage 10V
Maximum operating voltage  47V*
Continuous output current per channel  1.7A
Continuous paralleled output current 3.4A
Reverse voltage protection? Y*

*Note: Reverse voltage protection only works up to 40 V

Product Enquiry