+44 (0) 1761 234 328

(0) items

€0.00

You have no items in your shopping cart.

DRV8825 Stepper Motor Driver Carrier, High Current

Product Code: 2133
Excl. VAT: €8.22 Incl. VAT: €9.87
You will earn 7 Robo Points for buying this product

This breakout board for TI’s DRV8825 microstepping bipolar stepper motor driver features adjustable current limiting, over-current and over-temperature protection, and six microstep resolutions (down to 1/32-step).


It operates from 8.2 V to 45 V and can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (rated for up to 2.2 A per coil with sufficient additional cooling).


View our full range of Bipolar Stepper motors



  • Size: 0.6" x 0.8"

  • Weight: 1.6g (without headers)

This product is a carrier board or breakout board for TI’s DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (1MB pdf) before using this product.

This product is a carrier board or breakout board for Allegro’s A4988 DMOS Microstepping Driver with Translator and Overcurrent Protection; we therefore recommend careful reading of the A4988 datasheet (1MB pdf) before using this product.

  • Simple step and direction control interface
  • Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
  • Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
  • Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
  • 45 V maximum supply voltage
  • Built-in regulator (no external logic voltage supply needed)
  • Can interface directly with 3.3 V and 5 V systems
  • Over-temperature thermal shutdown, over-current shutdown, and under-voltage lockout
  • Short-to-ground and shorted-load protection
  • 4-layer, 2 oz copper PCB for improved heat dissipation
  • Exposed solderable ground pad below the driver IC on the bottom of the PCB

Specification:

  • Minimum operating voltage: 8.2 V
  • Maximum operating voltage: 45 V
  • Continuous current per phase: 1.5 A (without a heat sink or forced air flow)
  • Maximum current per phase: 2.2 A (with sufficient additional air cooling)
  • Minimum logic voltage: 2.5 V *
  • Maximum logic voltage: 5.25 V *
  • Microstep resolutions: full, 1/2, 1/4, 1/8, 1/16, and 1/32
  • Reverse voltage protection?: N
  • Bulk packaged: N
  • Header pins soldered: N (male header pins are included but not installed)

* This driver works with 2.5 V to 5.25 V logic. It does not take an external logic power supply.

Whenever possible, items which are in stock are dispatched the same day, or the next working day.

Large and/or heavy items are dispatched by UPS courier service and these orders must be placed before 15:00hrs (GMT) to ensure same day dispatch.

Small items are normally sent using a Royal Mail service for UK orders, and International Airmail or UPS for overseas orders

Returns Policy

DRV8825 Stepper Motor Driver Carrier close up

Videos

0

Enquiry Us

Post your comment

Active Robots