(0) items


You have no items in your shopping cart.

PIR Motion Sensor (JST)

Product Code: SEN-13285
Excl. VAT: £7.26 Incl. VAT: £8.71
You will earn 7 Robo Points for buying this product
This is a simple to use motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the 'alarm' pin will go low.

You can also install a jumper wire past the 5V regulator on board to make this unit work at 3.3V. Sensor uses 1.6mA@3.3V. The alarm pin is an open collector meaning you will need a pull up resistor on the alarm pin. The open drain setup allows multiple motion sensors to be connected on a single input pin.

If any of the motion sensors go off, the input pin will be pulled low. The connector is slightly odd but has a 0.1" pitch female connector making it compatible with jumper wires and 0.1" male headers.

  • Red wire is power (5 to 12V).
  • Brown wire is GND.
  • Black wire is open collector Alarm.
  • This unit works great from 5 to 12V (datasheet shows 12V).

Product Attachments

View FileSE-10 PIR Datasheet    Size: (50.54 KB)

Whenever possible, items which are in stock are dispatched the same day, or the next working day.

Large and/or heavy items are dispatched by UPS courier service and these orders must be placed before 15:00hrs (GMT) to ensure same day dispatch.

Small items are normally sent using a Royal Mail service for UK orders, and International Airmail or UPS for overseas orders

Returns Policy

PIR Motion Sensor (JST)

Enquiry Us

Post your comment

Active Robots