4 Channel Boosted Servo Extension via CAT6
This Boosted Servo Extension lets you control up to four servos over a CAT6 cable.
Details
This approach allows you to control your servos from a distance with the rock-solid connectivity of a wired setup. It can control up to four servos at once, making it useful if you need to tidy up the wiring on your project.
- Includes 1 Sending Board w/case, 1 Receiving Board w/case, and 4 servo extensions.
COMPATIBILITY
Ethernet Cables: While CAT6 is the recommeded cable, the RJ45 connector this Boosted Servo Extension uses is also compatible with CAT5, CAT5e, CAT6a, and CAT8 cables.
RC Receivers: This Boosted Servo Extension is compatible with any receiver which uses a PWM signal. This is just about any receiver in the hobby or small-medium robotics industries.
Servos: This Boosted Servo Extension is compatible with any servo which uses a PWM signal. This is just about any servo in the hobby or small-medium robotics industries.
Actobotics Electronics: While this Boosted Servo Extension uses CAT6, it utilizes a newer protocol than the Actobotics CAT6 boards (605102, 605103, 902MSD) making them incompatible with each other.