3802-2745-4527

4 Channel Boosted Servo Extension via CAT6, 3802-2745-4527

Only 1 left
£28.25 £23.54

This Boosted Servo Extension lets you control up to four servos over a CAT6 cable.

Or

This approach allows you to control your servos from a distance with the rock-solid connectivity of a wired setup. It can control up to four servos at once, making it useful if you need to tidy up the wiring on your project.

  • Includes 1 Sending Board w/case, 1 Receiving Board w/case, and 4 servo extensions.

 

COMPATIBILITY

Ethernet Cables: While CAT6 is the recommeded cable, the RJ45 connector this Boosted Servo Extension uses is also compatible with CAT5, CAT5e, CAT6a, and CAT8 cables.

RC Receivers: This Boosted Servo Extension is compatible with any receiver which uses a PWM signal. This is just about any receiver in the hobby or small-medium robotics industries.

Servos: This Boosted Servo Extension is compatible with any servo which uses a PWM signal. This is just about any servo in the hobby or small-medium robotics industries.

Actobotics Electronics: While this Boosted Servo Extension uses CAT6, it utilizes a newer protocol than the Actobotics CAT6 boards (605102, 605103, 902MSD) making them incompatible with each other.

Recommended Voltage Range 6V -15V
Max Voltage Range 3.3v - 18V
Signal Channels 4
Max Current (When powered at Receiving Board) 16A Total (4A per Channel)
Max current over CAT6 (When powered at Sending Board) 4A Total
Servo compatibility Analog & Digital
Maximum Recommended Ethernet Cable Length 100ft (30M)
Power Compatibility TJC8, XT30, 3mm Solder Holes