DCC1100_0 Brushless DC Motor Controller
Control a brushless DC motor from your VINT Hub. The hall effect input enables easy position and velocity control.
The DCC1100 requires an 8-30V DC power supply and can control one brushless DC motor. The motor must have hall-effect feedback for this controller to function. The DCC1100 has a 5-pin Molex connector to interface with the motor's hall-effect output. This Phidget connects to your computer through a VINT Hub.
Features:
- Control motor velocity, acceleration, and braking strength - Forward and reverse
- Set a specific target position
- Monitor Temperature - Your program can react to changes in controller temperature.
Technical Details:
- Isolation - The VINT port on this device is isolated, improving reliability and eliminating ground loops
- Overcurrent Protection - Onboard fuse to protect the controller in an over-current event
- Overheating Protection - A built-in heatsink prevents overheating
- Failsafe Protection - Set the device to turn off automatically if your program becomes unresponsive.
|
Board Properties |
|
|
Controlled By |
VINT |
|
Electrical Properties |
|
|
Supply Voltage Min |
8 V DC |
|
Supply Voltage Max |
30 V DC |
|
Current Consumption (Unconfigured) |
(VINT Port) 500 μA |
|
Current Consumption Max |
(VINT Port) 650 μA |
|
Replacement Fuse |
20A Slow Blow Blade Type, Standard or Micro |
|
Continuous Motor Current Max |
20 A |
|
Controller Properties |
|
|
Motor Type |
Brushless DC |
|
Number of Motor Ports |
1 |
|
Velocity Resolution |
0.003 Duty Cycle |
|
Hall-Effect Sensor |
|
|
Hall-Effect Voltage |
5 V DC |
|
Physical Properties |
|
|
Operating Temperature Min |
-40 °C |
|
Operating Temperature Max |
85 °C |
