3323_0 35STH36 NEMA 14 Bipolar Gearless Stepper
This NEMA-14 motor generates 1.4 Kg-cm of torque at 1 Amp. It comes with the rear shaft exposed, so you can mount an encoder or shaft coupler.
This bipolar stepper with rear shaft has a 1.8° step angle and 1.2 kg·cm of torque at low speeds.
When connected to a 1067 - PhidgetStepper Bipolar HC, the 3323 has a maximum speed of approximately 2340 RPM at zero load.
The 3323 stepper motor connects to a bipolar motor controller such as the 1067 - PhidgetStepper Bipolar HC.
The following diagram shows how to connect the motor wires to the board connectors to produce a clockwise rotation in the stepper motor when increasing position. To wire for counter-clockwise rotation when increasing position, reverse the red and blue wires.
Note: Make sure to unplug the power cord from the motor controller before switching wires around.
The rear shaft of this motor can be equipped with the HKT22 Optical Encoder for applications where you need to keep track of the exact position, velocity, or acceleration of the motor.
|Motor Type||Bipolar Stepper|
|Manufacturer Part Number||35STH36-1004B|
|Step Accuracy||± 5 %|
|Holding Torque||1.4 kg·cm|
|Rated Torque||1.2 kg·cm|
|Maximum Speed (w/1063 Motor Controller)||525 RPM|
|Maximum Speed (w/1067 Motor Controller)||2340 RPM|
|Acceleration at Max Speed
(w/1067 Motor Controller)
|1E+06 1/16 steps/sec²|
|Recommended Voltage||12 V DC|
|Rated Current||1 A|
|Coil Resistance||2.7 Ω|
|Shaft Diameter||5 mm|
|Rear Shaft Diameter||3.8 mm|
|Mounting Plate Size||NEMA - 14|
|Number of Leads||4|
|Wire Length||300 mm|
Connecting the motor directly to a power supply will destroy the motor and void the warranty. If you want to check your motor make sure it is connected to a constant current / chopper drive controller.