1064_1B Phidget Motor Control HC
Control up to two DC motors with this controller. Monitors surges and overheating in the API and connects to a USB port.
The PhidgetMotorControl HC allows you to control the angular velocity and acceleration of up to two high-current DC motors.
The 1064:
- Provides bi-directional control to 2 DC motors
- Requires external 6 to 15VDC Power Supply
- USB port is isolated from the motor control outputs
- Over voltage, over temperature, over current conditions are fed back to the API on the PC
Many variations of brushed DC motors exist: permanent magnet motors, electromagnet motors, coreless motors, linear motors... the PhidgetMotorController can be used with any of these.
Comes Packaged with
Hardware mounting kit:
- 4x M3 Bolts (2cm Length)
- 4x Plastic spacers (5mm Length)
- 4x M3 Nuts
|
Controller Properties |
|
|
API Object Name |
MotorControl |
|
Motor Type |
DC Motor |
|
Number of Motor Ports |
2 |
|
Velocity Resolution |
0.79 % Duty Cycle |
|
Acceleration Resolution |
1.9 % Duty Cycle/s |
|
Acceleration Min |
1.9 % Duty Cycle/s |
|
Acceleration Max |
1940 % Duty Cycle/s |
|
Acceleration Time Min |
52 ms |
|
Acceleration Time Max |
105 s |
|
PWM Frequency Max |
20 kHz |
|
Board Properties |
|
|
Controlled By |
USB |
|
API Object Name |
DCMotor |
|
Electrical Properties |
|
|
Supply Voltage Min |
6 V DC |
|
Supply Voltage Max |
15 V DC |
|
Continuous Motor Current Max |
(per motor) 14 A |
|
Surge Current Max |
(per motor) 32 A |
|
Overcurrent Trigger |
(combined) 50 A |
|
Current Consumption Max |
100 mA |
|
Current Consumption Min |
15 mA |
|
USB Speed |
Full Speed |
|
Physical Properties |
|
|
Recommended Wire Size |
10 - 26 AWG |
|
Operating Temperature Min |
0 °C |
|
Operating Temperature Max |
70 °C |
Documents
Library & Driver Downloads
