Traxster II Robot Chassis Kit

The Traxster Robot Kit was designed to be used as an indoor educational robotics kit and features a very rugged anodized aluminum chassis, driven by two 7.2V DC gear head motors, running on a set of ABS injection molded tracks.

Kit does not contain any electronics.

The Traxster can easily manoeuvre on carpet and other types of flooring, as well as traverse over small obstacles. The Traxster's skid-steer drive tracks enables it to spin about its center.

Features

• Rugged lightweight design
• Powder coated (orange, grey, black) aluminium components
• DC Gear head motors
• Quadrature wheel encoders, wire leads, & 0.100" headers
• Servo Hole
• Predrilled holes for 12C line following sensor
• Predrilled holes for push button I/O, LED, buzzer board
• Predrilled holes for Bluetooth/XBee Antenna
• Predrilled holes for Serializer
• Predrilled holes for 5V switching regulator
• Predrilled holes for dual switches/wiring harness, and wire routing
• Predrilled holes for Sharp IR Sensors in top/front of chassis
• Rear horizontal slots for mounting additional accessories
• Fully enclosed chassis (removable bottom)
• Space for two 9.6V batteries with easy access
• Space to mount and protect electronic components

Base Kit Dimensions

• Length: 9 inches (229 mm)
• Width: 8 inches (203 mm)
• Height: 3 inches (76 mm)
• Weight: 2.0 lbs. (32 ounces)
• Ground Clearance: .75 inches (19 mm)

Traxster II Kit Includes

• Powder coated (orange) aluminium chassis
• Powder coated (grey) belly pan
• Powder coated (black) aluminium drive disks
• Aluminium drive hubs
• 7.2V DC gearhead motors: 1:52 gear reduction, 160 rpm (no load)
• Quadrature wheel encoders, wire leads & 0.100" header/connector
• Aluminium rear axles
• Stainless hardware
• Velcro battery straps
• One wiring harness