Aluminium Tubing
Connector Hub

High quality anodized Aluminium hub allows the Aluminium tubing sections (AT-01 thru AT-06) to be connected to Servo Brackets

Aluminium Tubing
Option Connector Hub (Single)

These hubs can be used with the ASB-19 and BBH-01 to make a lightweight but very strong tubing pivot.

12mm Hex Mounting Hub - 6mm shaft (pair)

High quality RC truck (12mm hex pattern) tire hub. Works with any motor with a 6mm shaft. For Off Road (TRC-01) and (TRC-03) tires.

Aluminium Tubing

High quality 0.50" 6061 T6 round Aluminium tubing with mounting holes for mounting to HUB-08.

Tubing Lengths we offer.

• 1.5" (£1.29), 3.0"(£1.98), 4.5"(£2.59), 6.0"(£3.10), 2.25"(£1.72), 3.375"(£2.16) (+VAT to price)
• Sold individually

Please Select Length in Shopping Basket

Square (4-sided) Aluminium Hub Connector

High quality Aluminium hub connector cube allows the Aluminium tubing connector hub (HUB-08) to be connected together.

Cube (5-sided) Aluminium Hub Connector

High quality Aluminium hub connector cube allows the Aluminium tubing connector hub (HUB-08) to be connected together.

Hexagon Aluminium Hub Connector

High quality Aluminium hub connector hexagon allows the Aluminium tubing connector hub (HUB-08) to be connected together.

Aluminium Passive Hinge with Ball Bearings Single Pack

High quality black anodized Aluminium "Passive Hinge" bracket with ball bearings works great with Multi-Purpose Servo Bracket or another passive hinge. Useful for making parallelogram joints, or indirect drive joints with a mechanical advantage.

Load Balancing Spring

These steel music wire extension springs are perfectly suited to load balance joints made with brackets.

They are 1.5" total length and have a Load Lbs rating of 1.58 lbs.

6 high quality stainless steel threaded rods. (2-56 x 12")

6 high quality stainless steel threaded rods. (2-56 x 12")

Stainless Steel Threaded Rod (4-40 x 12")

6 high quality stainless steel threaded rods. (4-40 x 12")

Rubber End Caps

Can be used with Aluminium tubing. (AT-01 through AT-06)

Aluminium Chassis Bracket - 3" (pair)

These Chassis Brackets are used in the HBK-03 chassis for the front and rear panels. They can be used in place of the hex standoffs to add side panels. Up to two pairs of Chassis Brackets can be used.

Aluminium Robot Feet (Pair)

These Aluminium robot feet measure 2.50" x 4.75". They have a bend on the long dimension for added strength, and some holes to lighten the foot. They will work perfectly for a humanoid biped design.

Aluminium Hex Standoffs (F/F) - 1-15/16" x 1/4" (4-40 Tapped) (10)

Bumper Switch Assembly Kit

The ubiquitous "Bumper Switch" or "Whisker Sensor" easily attaches to most of our Robot Kits. This sensor kit requires soldering. Includes the materials and mounting hardware for two 6" whiskers.

SES Electronics Carrier

This is a compact electronics carrier made for the servo erector set. It has holes with the erector set pattern, and holes for ASB-02s mounted with rivet fasteners. Either a single board or two boards can be mounted.

This kit does not contain circuit boards

Know somone who might be interested? Share it with them!