10way Molex Crimp housing with pre-crimped leads

This connection lead set simplifies connectivity to industry standard Molex 10way 2.54mm (0.1") pitch headers.

8way Molex Crimp housing with pre-crimped leads

This connection lead set simplifies connectivity to industry standard Molex 8way 2.54mm (0.1") pitch headers.

8way Molex crimp housing split into two 4way housings

This connection lead set simplifies connectivity to industry standard Molex 8way/4way 2.54mm (0.1") pitch headers.

3way JST IDC housing with pre-crimped leads

Twelve-inch cable providing a JST miniature 3-pin connector with 3 machine crimped 26gauge stranded wires. The wires are colour coded for logical interface to the Sharp IR sensors. The free ends of the wires are not terminated.

GP Servo Lead (UNI)

A good quality general purpose servo lead with gold contact pins measuring 300mm long.

Click to Enlarge

Servo Extender Cable - 6"

Easily extend the distance a servo can be from the control electronics. Works with RC receivers or servo controllers. Remove the pins and it becomes a female to female cable for the PING or other three pin device.

Click to Enlarge

Servo Extender Cable - 12"

Easily extend the distance a servo can be from the control electronics. Works with RC receivers or servo controllers. Remove the pins and it becomes a female to female cable for the PING or other three pin device.

Click to Enlarge

Servo Extender Cable - 24"

Easily extend the distance a servo can be from the control electronics. Works with RC receivers or servo controllers. Remove the pins and it becomes a female to female cable for the PING or other three pin device

Click to Enlarge

Servo "Y" Adapter Cable

Easily control two servos from the same channel. Works with RC receivers or servo controllers.

Click to Enlarge

Sharp GP2D12 IR Cable - 8"

This cable makes it easy to use the Sharp GP2D12 Infrared Sensor. It is prewired with the JST connector on one end, and the standard 0.1" spaced connector on the other. The end terminates with a power and data connection. These can be plugged into the Bot Board for imediate use. The cable is three circuits, black, red, and yellow.

Click to Enlarge

Data Cable (3 Circuit) - 8"

This cable is used to connect signal lines to a peripheral device. It can be used for any 0.1" spaced header such as the Bot Board. The cable is three circuits, violet, blue and yellow.

Tamiya Wired Connectors

Handy Tamiya style connectors available separately in both male and female versions pre–fitted with good quality 16AWG cable. The plain cable end has been soldered tinned for easy application to a battery or speed controller.

Know somone who might be interested? Share it with them!