+44 (0) 1761 234 328

(0) items

£0.00

You have no items in your shopping cart.

DRV8825 Stepper Motor Driver Carrier, High Current

Product Code: 2133
Excl. VAT: £7.15 Incl. VAT: £8.58

This breakout board for TI’s DRV8825 microstepping bipolar stepper motor driver features adjustable current limiting, over-current and over-temperature protection, and six microstep resolutions (down to 1/32-step).


It operates from 8.2 V to 45 V and can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (rated for up to 2.2 A per coil with sufficient additional cooling).


View our full range of Bipolar Stepper motors



  • Size: 0.6" x 0.8"

  • Weight: 1.6g (without headers)

This product is a carrier board or breakout board for TI’s DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (1MB pdf) before using this product.

This product is a carrier board or breakout board for Allegro’s A4988 DMOS Microstepping Driver with Translator and Overcurrent Protection; we therefore recommend careful reading of the A4988 datasheet (1MB pdf) before using this product.

  • Simple step and direction control interface
  • Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
  • Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
  • Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
  • 45 V maximum supply voltage
  • Built-in regulator (no external logic voltage supply needed)
  • Can interface directly with 3.3 V and 5 V systems
  • Over-temperature thermal shutdown, over-current shutdown, and under-voltage lockout
  • Short-to-ground and shorted-load protection
  • 4-layer, 2 oz copper PCB for improved heat dissipation
  • Exposed solderable ground pad below the driver IC on the bottom of the PCB

Specification:

  • Minimum operating voltage: 8.2 V
  • Maximum operating voltage: 45 V
  • Continuous current per phase: 1.5 A (without a heat sink or forced air flow)
  • Maximum current per phase: 2.2 A (with sufficient additional air cooling)
  • Minimum logic voltage: 2.5 V *
  • Maximum logic voltage: 5.25 V *
  • Microstep resolutions: full, 1/2, 1/4, 1/8, 1/16, and 1/32
  • Reverse voltage protection?: N
  • Bulk packaged: N
  • Header pins soldered: N (male header pins are included but not installed)

* This driver works with 2.5 V to 5.25 V logic. It does not take an external logic power supply.

FeeFo Reviews

This product has no reviews yet.

Whenever possible, items which are in stock are dispatched the same day, or the next working day.

Large and/or heavy items are dispatched by UPS courier service and these orders must be placed before 15:00hrs (GMT) to ensure same day dispatch.

Small items are normally sent using a Royal Mail service for UK orders, and International Airmail or UPS for overseas orders

Returns Policy

DRV8825 Stepper Motor Driver Carrier close up

Videos

0
Post your comment

Active Robots