You have no items in your shopping cart.
Product Code: BOB-12731Excl. VAT: £10.30 Incl. VAT: £12.36
This is the SparkFun USB to Serial Breakout for the FT232RL, a small board with a built in USB to serial UART interface.
This little breakout is built around the FT232RL IC from FTDI, with an internal oscillator, EEPROM, and a 28-pin SSOP package this is a serious little chip.
Product Code: SEN-11084Excl. VAT: £10.15 Incl. VAT: £12.18
The MPL3115A2 is a MEMS pressure sensor that provides Altitude data to within 30cm (with oversampling enabled).
The sensor outputs are digitized by a high resolution 24-bit ADC and transmitted over I2C, meaning it’s easy to interface with most controllers.
Pressure output can be resolved with output in fractions of a Pascal, and Altitude can be resolved in fractions of a meter. The device also provides 12-bit temperature measurements in degrees Celsius.
Product Code: SEN-11295Excl. VAT: £22.50 Incl. VAT: £27.00
The HIH6130 is a digital output-type relative humidity (RH) and temperature sensor combined in the same package.
This allows the RH measurement to be temperature compensated and provides a second, standalone temperature sensor output.
Product Code: SEN-12916Excl. VAT: £99.45 Incl. VAT: £119.34
The HMC6343 is a fully integrated high end electronic compass module that can compute and give you a heading direction that’s accurate within a couple degrees.
It is tilt compensated and is calibrated to handle magnetic distortions.
This breakout board allows for easy use of the HMC6343. All that is required is power and I2C connections to a microcontroller so that the module can receive commands and send data back to the user.
Product Code: SEN-12756Excl. VAT: £6.50 Incl. VAT: £7.80
This breakout board makes it easy to use the tiny MMA8452Q accelerometer in your project.
The MMA8452Q is a smart low-power, three-axis, capacitive MEMS accelerometer with 12 bits of resolution.
Product Code: SEN-12040Excl. VAT: £5.70 Incl. VAT: £6.84The INA169 is a “high-side current monitor,” which means that you place a resistor (a “shunt resistor”) on the positive power rail and the INA169 measures the voltage drop across that resistor.Add to Compare
Product Code: SEN-11486Excl. VAT: £22.50 Incl. VAT: £27.00
The SparkFun 9DOF MPU-9150 is the world’s first 9-axis MotionTracking MEMS device designed for the low power, low cost, and high performance requirements of consumer electronics equipment including smartphones, tablets and wearable sensors. And guess what? You get to play with it.
This breakout board makes it easy to prototype with the InvenSense MPU-9150 by breaking out all the pins you need to standard 0.1" spaced headers. The board also provides I2C pullup resistors and a solder jumper to switch the I2C address of the device.
Product Code: BOB-11736Excl. VAT: £9.72 Incl. VAT: £11.66
Introducing the 3.3V SparkFun FT231X Breakout board, complete with the full UART hardware handshake feature!
The pinout of this board matches the FTDI cable to work with official Arduino and cloned 3.3V Arduino boards.
Minimal Price: £0.60