The three-wire servo lead has been regulated into a Grove standard connector. You can plug and play it as a typical Grove module now, without jumper wires clutter.
The Servo has three wires: power, ground, and signal. The power wire is typically red, and should be connected to the 5V pin on the Arduino/Seeeduino board.
The ground wire is typically black or brown and should be connected to a ground pin on the Arduino board.
The signal pin is typically yellow, orange or white and should be connected to Digital 9 on the Arduino board.
You can change to the digital port as you like. But don't forget to change the port number in the definition of the demo code at the same time.
- 1 Servo Servos
- 3 Servo Horns
- 3 Screw
Please visit the wiki page for more info about this product.