A very familiar application of a through beam photoelectric sensor can be found is right in your home. Quite often, a garage door opener has a through beam photoelectric sensor mounted near the floor, across the width of the door. This sensor is making sure nothing is in the path of the door when it is closing.
The Phidgets Digital Input is "off" when the receiver receives the transmitter signal (i.e. there are no objects between the transmitter and the receiver); the Digital Input is "on" when the beam is broken by the presence of an object.
- Through Beam Emitter and Receiver using an Infrared LED
- Standard Detecting Distance: 10m
- NPN, Normally Open (NO) Output
- PVC Cable 2m
- Requires a 12 to 30VDC Power Supply
You need to provide 12VDC to the Transmitter. The brown wire is +V and the blue wire is GND.
This is how you connect the 3525 Receiver to a Phidget board that does not have 12V power such as the 1018, 1012, 1202, and 1203 using our 12VDC Power Supply:
- Connect the +12 wire from the Power Supply (that's the one with the white line) to the 3525 Brown wire.
- Connect the 3525 Black wire to a Digital Input on the 1018.
- Connect the Power supply Ground Wire and the 3525 Blue wire to the Digital Input Ground connector on the 1018.
Note: When the 3525 Receiver is connected to a 1012, it will behave as a Normally Close (NC) sensor instead of Normally Open (NO).
For boards that have power input, if the supplied power is within 12-24VDC, the +V line can be connected to the terminal block, powering the sensor from the Phidget. The 1019, 1070, 1060 and 1063 all accept external power.